Precautions when performing preset – Yamaha AV-S70 User Manual

Page 27

Advertising
background image

25

English

REMO

TE CONTR

OL

APPENDIX

PREP

ARA

TION

OPERA

TION

OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL

6

Point the remote control at the component to
be controlled (the component turned on in
step 1) and press

p

repeatedly until the

component’s power turns off.

If the transmission indicator flashes twice, this
indicates that you have cycled through all the codes
stored in the memory of the remote control. Up to 300
manufacturer codes (for TV) may be stored in the
memory of the remote control. Since a manufacturer
code is set by pressing p and cycling in order through
these codes, you may need to press p up to 300 times
to reach the proper code.

y

Up to 120 manufacturer codes for VCR, 170 for satellite tuner and
20 for cable TV may be stored in the memory of the remote control.

Note

• If you accidentally press p too many times after the power is

turned off, you may press m the same number of times to go
through the manufacturer codes in reverse order. The correct
manufacturer code will not be set unless you do this.

7

6

7

Press the remote control selector button you
pressed in step 2.

The indicator will go out.

The transmission indicator will go out once auto preset
has been performed properly.

Note

• During step 6, if you press p about 300 times and the

transmission indicator flashes twice slowly and the component’s
power still has not turned off, this indicates that auto preset
cannot be performed for the component in question. Check that
the component to be controlled supports remote control operation.
You may also try performing manual preset.

Precautions when performing
preset

The transmission indicator will go out once the
manufacturer code has been set properly.

If the transmission indicator does not go out, or if it flashes
and then goes out, repeat the procedure from step 1. Pay
attention to the following points when you repeat the preset
procedure.

Check the manufacturer code number.

Check that the correct remote control selector button has
been selected when setting the manufacturer code.

If more than one code is given for a manufacturer, try
entering each code in the order given.

Remove and replace the remote control’s batteries
(complete this step within 2 minutes) and then repeat the
procedure.

To clear a manufacturer code

Perform the procedure “Using manual preset” described on
page 23 and enter the following codes when you reach
step 3.

To clear the “TV” button: 0000

To clear the “VCR” button: 0000

To clear the “SAT” button: 0000

To clear all buttons for “TV”, “VCR” and “SAT”: 9990

Transmission
indicator

0105AV-S70_23-30_EN

3/29/0, 4:04 PM

25

Advertising