Yamaha DSP5D - Manual (Page 237)

PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
237
Information shown
in the display
Function
menu
Global
functions
Output
functions
Input
functions
Appendices
H WIDTH
I INTERVAL
If burst noise is selected, these knobs select the dura-
tion of the noise itself (WIDTH) and the duration of
silence between noise bursts (INTERVAL).
The range is 0.1–10 sec for WIDTH, and 1–30 sec for
INTERVAL. (The current setting is shown in the box
below each knob.)
J OSC OUT (Oscillator direct output)
This indicates the channel of the output jack / slot that
directly outputs the oscillator signal. If you want to
change the output destination, click the PATCH but-
ton to access the OUTPUT PATCH screen.
If SINE WAVE 2CH is selected, the L channel of the
oscillator is sent to the oscillator direct output.
K BUS ASSIGN
Here you can select the bus(es) or output jack(s) from
which the sine wave or noise will be sent. (Multiple
selections are allowed.)
MIX 1–24 . . . . . . . . MIX bus 1–24
MATRIX 1–8 . . . . . . MATRIX bus 1–8
AL/AR . . . . . . . . . . . STEREO A bus L/R channels
BL/BR . . . . . . . . . . . STEREO B bus L/R channels
If SINE WAVE 2CH is selected, the L channel of the
oscillator is output to the odd-numbered bus or the L
jack, and the R channel of the oscillator is output to the
even-numbered bus or the R jack.
This screen contains various settings and indications for
2TR IN / 2TR OUT.
Note
The 2TR I/O screen is disabled if the DSP5D is selected.
A Input level meters
These indicate the input level of 2TR IN DIGITAL
jacks 1–3 and 2TR IN ANALOG jacks 1–2.
B FREQUENCY (Sampling frequency)
Indicates the sampling frequency of the input signal
from 2TR IN DIGITAL jacks 1–3.
C SRC (Sampling Rate Converter)
These are on/off switches for the sampling rate con-
verters built into 2TR IN DIGITAL jacks 1–3.
(If turned off, this indicates “THROUGH.”)
D EMPHASIS STATUS
Indicates whether emphasis processing is being applied
to the input signal from 2TR IN DIGITAL jacks 1–3.
INTERVAL
WIDTH
Level
Time
Pink noise output
The BURST NOISE button is on
J
K
2TR I/O screen
2TR I/O
1
2
3
4