Yamaha DSP5D - Manual (Page 262)

MATRIX/ST function
262
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
C SET BY CUE (Assign by [CUE] key)
This specifies whether the [CUE] key will be used to
make/cancel compressor link group assignments.
While the compressor link group SET BY CUE button
is on, pressing the [CUE] key of a channel that can be
assigned to the corresponding group will assign the
channel to the group. (Press the [CUE] key once again
to cancel the assignment.)
Hint
The SET BY CUE button can be turned on for only one com-
pressor link group. This is automatically turned off when you
change screens or turn off the power.
D CLEAR
This button clears all output channels assigned to that
compressor link group.
MATRIX/ST function
Here you can send the signal from MIX channels and STE-
REO A/B channels to the STEREO bus or the desired
MATRIX bus.
A MATRIX bus
This is the number of the MATRIX bus to which the
signal is sent. Paired MATRIX channels are indicated
by a heart symbol displayed between them. You can
click this symbol to enable/disable pairing.
B Send level
These knobs specify the send level of each signal that is
sent from the MIX channel or STEREO A/B channel
(vertical column) to the MATRIX buses (horizontal
row).
The knobs shown in this area will depend on how the
MATRIX channels are paired.
4 3
MATRIX/ST ROUTING screen
MATRIX/ST ROUTING
2 1
MIX channel
STEREO A/B channel