Yamaha DSP5D User Manual
Page 302
PAN/ROUTING function
302
PM5D/PM5D-RH V2 / DSP5D Owner’s Manual
Reference section
❏ Type = VARI, Pairing = enabled
E PRE EQ/PRE FADER
These buttons let you specify in greater detail the loca-
tion from which the pre-fader signal will be sent from
an input channel to the MIX buses. You can choose
one of the following two send locations.
Hint
This setting applies to the signal sent from the corresponding
input channel to all MIX buses.
F FOLLOW PAN
These buttons specify how the TO ST PAN knob (
8
)
will affect the signal sent from the input channel to
MIX buses.
• VARI
If this button is on, the PAN knob displayed in the CH
to MIX area (
4
) will be linked with the TO ST PAN
knob (
8
) if VARI-type MIX buses are paired.
• FIXED
If this button is on, the signal from after the TO ST
PAN (
8
) knob will be sent to FIXED-type MIX buses.
G TO ST (To stereo)
This button specifies whether the input channel / ST
IN channel will send its signal to the STEREO bus. This
is linked with the [TO STEREO] switch in the
SELECTED CHANNEL section.
H TO ST PAN (To stereo pan)
Here you can adjust the panning of the signal sent from
the input channel / ST IN channel to the STEREO bus.
(The current value is shown in the boxes immediately
below.) This is linked with the encoder if PAN is
selected as the encoder mode, and with the [PAN]
encoder of the SELECTED CHANNEL section.
I PAN MODE
Here you can select one of the following ways in which
pan settings will be linked between adjacent odd-num-
bered/even-numbered input channels (or the left/right
channels of a ST IN channel).
• INDIVIDUAL
The two pan settings will be independent.
• GANG PAN
The two pan settings will be linked in the same direc-
tion. If the two pan values are different when you turn
on this button, pan will be linked while preserving the
existing difference in values.
• INV. GANG (Inverted gang)
The two pan settings will operate in opposite
directions.
Input channel 1
↓
MIX buses 1/2
Input channel 2
↓
MIX buses 1/2
SEND ON/OFF
button
On/off switch for
the signal sent
from input chan-
nels to the two
MIX buses.
PRE/POST button
Selects either PRE (pre-EQ or pre-fader) or POST
(post ON or post TO ST) as the location from which the
signal will be sent from input channels to each MIX bus.
MIX PAN/BALANCE knob
Specifies the panning of the signal sent
from input channels to the two MIX
buses. If the PAN MODE (9) of the
input channel is set to BALANCE, this
functions as a BALANCE knob that
adjusts the volume balance between
the two channels.
SEND LEVEL knob
Adjusts the level of the signal
sent from input channels to the
two MIX buses.
MIX1
MIX2
STEREO L
STEREO R
……
……
MIX1
MIX2
STEREO L
STEREO R
……
……
INPUT CHANNEL 1
FADER
INPUT CHANNEL 1
ON
ON
PAN
PAN
MIX1/2 (VARI)
LEVEL
FADER
ON
ON
PAN
PAN
MIX1/2 (VARI)
LEVEL
• PRE/POST button= PRE
• PRE/POST button= POST
PRE FADER
Immediately before the fader
PRE EQ
Immediately before the EQ
5
9
J
7
K
8
6