Yamaha DSP5D - Manual (Page 63)

PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Operating section
63
6
Output channel operations
MATRIX section
In the MATRIX section you can adjust the send levels from MIX channels to MATRIX buses, and adjust the output level of
the MATRIX channels.
A DCA group LEDs
The LED of the DCA group to which this MATRIX
channel is assigned will light.
B MATRIX [PAIR] LED
This LED will light if adjacent odd-numbered/even-
numbered MATRIX channels are paired.
C MATRIX [ON] key
This switches the MATRIX channel on/off.
D MATRIX encoder
This adjusts the output level of the MATRIX channel.
E MATRIX [CUE] key
This is used to monitor a MATRIX channel via the Cue
Monitor/Solo function.
F MATRIX [SEL] key
This selects the MATRIX channel to which operations
in the SELECTED CHANNEL section or in the display
will apply.
❏ Sending signals from the MATRIX sec-
tion to output jacks
Here’s how the signals sent from MIX channels or STE-
REO A/B channels to MATRIX buses can be sent to the
MATRIX OUT jacks.
1 Make sure that appropriate signals are being
sent from the MIX channels or STEREO A/B
channels to the MATRIX buses.
2 In the MATRIX section, press the MATRIX [ON]
buttons to turn the desired MATRIX chan-
nel(s) on.
3 Turn the encoders of the MATRIX section to
adjust the output level of the MATRIX
channels.
The signals sent to the MATRIX bus(es) will be sent
from the corresponding MATRIX OUT jack(s).
4 To check the output level of the MATRIX chan-
nels, press the [MIX/MATRIX] key in the meter
section.
The [ST IN/MATRIX] meters will show the output
levels.
Hint
The detection point (metering point) of the signal levels shown
in the meters can be changed if desired (
➥ p.109).
❏ Pairing the MATRIX section
Adjacent odd-numbered/even-numbered MATRIX chan-
nels can be paired if desired. If two channels are paired,
their parameters (with the exception of pan and delay) will
be linked.
1 In the MATRIX section, hold down the MATRIX
[SEL] key for one of two adjacent odd-num-
bered/even-numbered channels, and press the
MATRIX [SEL] key of the other channel.
The [PAIR] LED will light, and the MATRIX channels
will be paired. At this time, the parameters of the chan-
nel whose MATRIX [SEL] key you pressed first will be
copied to the channel whose MATRIX [SEL] key you
pressed later.
For example if you pressed the keys in the order of
MATRIX channel 1
→ MATRIX channel 2, the param-
eters of MATRIX channel 1 will be copied to MATRIX
channel 2.
2 To defeat pairing, hold down the [SEL] key of
one of the paired MATRIX channels and press
the [SEL] key of the other MATRIX channel.
When MATRIX channels are paired, the signal flow
will change as follows.
Items in the MATRIX section
5
3
6
4
1 2
Operations in the MATRIX section
OVER
-3
-6
-9
-12
-15
-18
-24
-30
-40
-50
-60
OVER
-3
-6
-9
-12
-15
-18
-24
-30
-40
-50
-60
1 L 1R 2L 2R 3L 3R 4L 4R
MATRIX ST IN / /
1 2 3 4 5 6 7 8
MIX
PEAK
HOLD
CH 1 -24
ST IN/
/ST IN
MATRIX
ST/IN MATRIX meters
[MIX/MATRIX] key