Yamaha GX500 - Manual (Page 16)

E-6
Preparations and connections
Ⅵ
Connecting an external component
This system can be connected with an external audio
component. Make connections between this system and the
component using RCA pin plug connector cables correctly,
that is to say L (left) to L and R (right) to R. Also, refer to the
owner’s manual for the component to be connected to this
system.
* A digital-to-digital recording is possible from a CD played on
the built-in CD player to an MD (or tape) on an external MD
recorder (or DAT) by connecting the DIGITAL OUT
(OPTICAL) terminal on the rear of the main unit to the MD
recorder (or DAT).
Ⅵ
Antenna connection
(1) Supplied FM antenna
Connect the FM antenna wire to the corresponding terminal
and direct the FM antenna wire to the direction where the
strongest signal can be received.
(2) Supplied AM loop antenna
Connect the AM loop antenna wires to the corresponding
terminals. Position the AM loop antenna for optimum
reception.
Notes
●
When static is still heard even after adjusting the position of
the AM loop antenna, try reversing the wire connections
(from the right terminal to the left one, and vice versa).
●
The AM loop antenna should be placed apart from the main
unit. The antenna may be hung on a wall.
Using an external antenna
● Use an external FM antenna instead of an indoor FM
antenna if you need better reception. Consult your dealer.
●
Use an external AM antenna if you need better reception.
Consult your dealer.
R L
ANTENNA
75 Ω UNBAL.
FM GND AM
DIGITAL OUT
OPTICAL
OUT
R L
OUT
IN
SEE OWNE
FOR CONN
FRONT SPEAKERS
6 Ω MIN./
SUBWOOFER
AUX/MD
(1)
(2)
ANTENNA
75 Ω UNBAL.
FM GND AM
ANTENNA
75 Ω UNBAL.
FM GND AM
DIGITAL OUT OPTICAL
ANTENNA
75 Ω UNBAL.
FM GND AM
DIGITAL IN
IN OUT
(U.S.A. model)
(U.S.A. model)
MD recorder, etc.