Yamaha GX500 - Manual (Page 17)

English
E-7
DISC 1 DISC 2 DISC 3
DOWN UP
VOLUME
STANDBY/ON
YMERSION B.BOOST MUSIC INPUT INPUT
MIN
PRESET/ TUNING/ BAND A/B/C/D/E
DISC CHANGE OPEN / CLOSE
AUTO/MANUAL
TIMER
MEMORY
TIME ADJ
REC/PAUSE DOLBY NR
HOUR
RANDOM REPEAT TIME
DISPLAY MODE
DISC 1 DISC 2 DISC 3
3–DISC CD CHANGER
STANDBY TIMER
DOWN UP
VOLUME
STANDBY/ON
AUTO REVERSE CASSETTE DECK DOLBY B NR
DIRECTION
YMERSION B.BOOST MUSIC INPUT INPUT
PHONES
MIN
PRESET/ TUNING/ BAND A/B/C/D/E
DISC CHANGE OPEN / CLOSE
TREBLE BASS
AUTO/MANUAL
TIMER
MEMORY
TIME ADJ
REC/PAUSE DOLBY NR
HOUR
RANDOM REPEAT TIME
DISPLAY MODE
1
2
3
RANDOM REPEAT
HOUR MIN
RANDOM REPEAT
HOUR MIN
DISPLAY
MEMORY
TIME ADJ
MEMORY
TIME ADJ
1
While the power is on, press DISPLAY to display the time.
2
While holding TIME ADJ pressed, press HOUR and set the
hour.
* Press HOUR once to advance the time by 1 hour. Press
and hold to advance continuously.
3
While holding TIME ADJ pressed, press MIN and set the
minute.
* Press MIN once to advance the time by 1
minute. Press and hold to advance continuously.
* The hour setting will not advance even if minute is
advanced from “59” to “00”.
Australia model use a 24-hour display. U.S.A. and Canada
models use a 12-hour display. For China and General
models, either the 24-hour display or the 12-hour display
[shown by “AM (PM) 12:00”] is selected depending on the
setting of the FREQUENCY STEP switch on the rear
panel, so you cannot select the desired type freely.
Note
In the event of a power failure or when the AC supply lead is
disconnected, the time display will go out, however, the clock
will function for about 5 minutes without any power supply.
Otherwise, the time display will flash on and off to indicate that
the time must be reset.
If desired, you can adjust the brightness of the display.
Press and hold DISPLAY for more than 2 seconds so that
“DIMMER
±
0” appears on the display.
While holding DISPLAY pressed, turn VOLUME clockwise to
increase or counterclockwise to decrease brightness.
Control range:
±
0 to –6 (Preset value:
±
0)
Setting the clock
VOLUME
DISPLAY
Adjusting brightness of the display
Changes.
Changes.
Preparations and connections