Yamaha GX500 - Manual (Page 27)

E-17
English
DISC 1 DISC 2 DISC 3
DOWN UP
VOLUME
STANDBY/ON
DIRECTION
YMERSION B.BOOST MUSIC INPUT INPUT
MIN
PRESET/ TUNING/ BAND A/B/C/D/E
DISC CHANGE OPEN / CLOSE
AUTO/MANUAL
TIMER
MEMORY
TIME ADJ
REC/PAUSE DOLBY NR
HOUR
RANDOM REPEAT TIME
DISPLAY MODE
3
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9 0
TIME PROG R. TIME
C
EDIT
D
PRESET
+ I0
E
MODE REPEAT RANDOM TUNER
DISC SKIP
REC/PAUSE
DIRECTION
YMERSION BASS BOOST MUSIC
POWER SLEEP INPUT VOLUME
A B
TAPE
TUNER CD
/ I
Tuning operation
Automatic preset tuning
You can make use of an automatic preset tuning function. With
this function, the built-in tuner performs automatic tuning. Up
to 40 stations are stored automatically.
1
Turn on the power.
2
Press INPUT or until “TUNER” (
2
,
7
) appears on
the display, or simply press TUNER on the remote control.
3
Press and hold MEMORY for more than 2 seconds.
* The “MEMORY” (
6
) and “AUTO” (
4
) indicators flash.
The tuner performs automatic tuning and searches FM and
AM stations in that order. Received stations are programmed
to A1, A2 ... A8 sequentially.
When the automatic preset tuning is completed;
The display shows the frequencies of the first preset station
(stored to A1).
If you want to check the contents and the number of preset
stations, follow the procedure of the section “To recall a preset
station” on the previous page.
To recall a preset station
Simply follow the procedure of the section “To recall a preset
station” on the previous page.
Notes
● The automatic preset tuning search will be performed
through all frequencies until 40 stations are stored. If the
number of received stations is less than 40, the search will
stop after searching all frequencies.
* Since FM stations are searched for first, there may be a
case that 40 preset stations are occupied by FM stations
only.
● With this function, only stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune in to it with the
Manual tuning method (in monaural) and program it by
following the procedure of the section “To store stations” on
the previous page.
● You can replace a preset station with another FM or AM
station manually by simply following the procedure of the
section “To store stations” on the previous page.
2
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if the AC supply lead is disconnected
from the AC outlet or the power is cut due to temporary
power failure. If, however, the power is cut for more than
one week, the memory may be erased. If so, it can be
re-programmed by simply following the Preset tuning steps.
2
2
1
1