Dometic MCS15 - Manual (Page 10)

EN
Safety Instructions MCS5, MCS15
10
✓ This symbol describes the result of an action.
fig. 1 5, page 3: This refers to an element in an illustration. In this case,
item 5 in figure 1 on page 3.
2 Safety Instructions
The manufacturer accepts no liability for damage in the following cases:
 Faulty assembly or connection
 Damage to the product resulting from mechanical influences and
excess voltage
 Alterations to the product without express permission from the manu-
facturer
 Use for purposes other than those described in the operating manual
2.1 General Safety
! WARNING!

Danger of electrocution!
The units are AC voltage components, running on 230 V~.
 Electrical shock hazard!
Disconnect voltage at main panel or power source before opening any
cover.
Failure to comply may result in injury or death.
 To minimize the hazard of electrical shock and personal injury, this
component must be effectively grounded.
 This system does not meet requirements for ignition protection. Do not
install in spaces containing gasoline engines, tanks, LPG/CPG cylin-
ders, regulators, valves or fuel line fittings.
Failure to comply may result in injury or death.
 Do not terminate condensate drain line
– within 1 m of any outlet of engine or generator exhaust systems,
– in a compartment housing of an engine or generator,
– in a bilge, unless the drain is connected properly to a sealed con-
densate or shower sump pump.
Failure to comply may allow bilge or engine room vapors to mix with
the air conditioners return-air and contaminate living areas which
may result in injury or death.
 In order to prevent the ingress of carbon monoxide (CO) or other
harmful vapors, a trap should be installed in the condensate drain
line(s).
 Installation and servicing of this system can be hazardous due to
system pressure and electrical components.