SUUNTO Advizor - Manual (Page 46)

40
5.3 SEA LEVEL PRESSURE SUB MODE
Sea level pressure is pressure relative to sea level whereas the pressure read in the main barometer display is absolute
pressure in the current location.
In the Barometer mode, PRESS the [Select] button three times to enter this sub mode.
In the sea level pressure mode (Fig. 49):
• Field 1 displays the text “SEA”;
• Field 2 displays the current sea level pressure; and
• Field 3 displays the current time.
5.3.1 Setting the Sea Level Pressure
If the altitude is not known, setting the sea level pressure can be used in setting the altitude measurement on the Wristop
Computer.
To set the sea level pressure (Fig. 50):
1. PRESS the [Select] button and hold in for 2 seconds. Located in Field 2, the current sea level pressure will begin to
flash.
2. PRESS the [+] button to scroll the pressure upward or PRESS the [-] button to scroll the pressure downward.
3. At the desired pressure, PRESS the [Mode] button to accept the changes and return to the main mode.
Once the user completes this process, the altitude measurement on the Wristop Computer is correct within approximately
ten meters or 30 ft.
Note: Information on the current sea level pressure can be obtained through newspapers, local news and radio weather
reports, the local airport facility or through the Internet under local weather.
Note: If the user does not press any button for 1 minute in the setup mode, the display will automatically exit setup.