STIEBEL ELTRON SBB WP SOL с 12.05.2008 - Manual (Page 16)

HTV`.HC
ù¼|ĉêĉÖ© ›|ļ¼ |ĉ® ă|êĉŒ¼ĉ|ĉ›¼
Ĝō ’Z
ŗƃĜéÑƃĜ qT ZH< ŷŷŷĪńŒê¼¼ùé¼ùŒļĒĉĪ›Ēă
4. Cleaning, care and maintenance
f Have the function of the safety assembly and electrical safety
of the fitted accessories regularly checked by a qualified
contractor.
f Never use abrasive or corrosive cleaning agents. A damp
cloth is sufficient for cleaning the appliance.
4.1 Signal anode consumption indicator


Material losses
If the consumption indicator changes colour from white to
red, have the signal anode checked by a heating contrac-
tor and if necessary replaced.
2
6
_0
3
_2
0
_000
1
2 3 1
1 Signal anode consumption indicator
2 white = anode OK
3 Red
= check by heating contractor required
4.2 Scaling
f Almost every type of water deposits limescale at high tem-
peratures. This settles inside the appliance and affects both
the performance and service life. If a flanged immersion
heater is installed, the heating elements must be descaled
from time to time. A heating contractor who knows the local
water quality will tell you when the next service is due.
f Check the taps/valves regularly. You can remove limescale
deposits at the tap outlets using commercially available des-
caling agents.
5. Troubleshooting
Telephone your contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-000000):
1U     
0DGH LQ *HUPDQ\ 2
6
_0
3
_2
0
_000
2