TIMBERK THU UL 07 series - Manual (Page 4)

6. FILLING TANK WITH WATER
Prior to filling the tank remove the atomizer from the tank. If you fail to do
so, then upon turning over the tank the atomizer will fall down. The device
must not be operated without the atomizer.
When moving the humidifier do not grab the water tank handle. You
should hold the humidifier by the base.
1. Remove the atomizer and then the water tank from the device.
2. Grab the tank handle and pull it upwards.
3. Unscrew the tank cap counterclockwise.
4. Fill the tank with water.
5. Screw the tank cap clockwise.
Make sure the tank cap is securely tightened. Be sure that the rubber
gasket is installed to the tank cap. Securely tighten the cap clockwise.
Incomplete fulfillment of the abovementioned measures causes the air
coming into the water tank and, as a result, a failure.
6. Install the tank and the atomizer to the device.
Fig. 2
9
10
11
12
13
14
15
16
* Sprayer rotates 360 °, the direction of spray vapor is adjusted manually
by the user.
9 - indicator output intensity of the pair
10 - indicator of the current and desired humidity level
11 - Power on / off
12 - button to turn off the timer from 1 to 12 hours
13 - Power on / off ionizer
14 - Button adjust the intensity of the steam
15 - Button set the desired humidity level - an increase of 80%
16 - Button set the desired level of humidity - a reduction of up to 40%
The display may reflect other indicators, it depends on a series of output
device. All the indicators corresponding to a particular mode of
operation (depending on user settings). For some series using water
level indicator, which signals the absence of water.
5. SCOPE OF DELIVERY
1. Humidifier 1 pc.
2. Operation manual 1 pc.
3. Guarantee card 1 pc.
4. Packing 1 pc.
5. Cleaning brush - 1pc.
IMPORTANT!
1. To prevent an electric shock, prior to dismantling the device
(removing the tank), unplug the device from electric mains!
2. Do not fill the tank with liquids other than tap water.
Other composition of liquids has an adverse effect on internal
parts and results in a failure.
3. Do not fill the device or the water tank with such additives as
essential oil, flavoring substance, detergent, chemical medical
products, warm water (over 40°), etc.
Otherwise the water tank and internal parts of the unit will be
damaged and be broken.
4. Do not fill water directly into the internal part of the unit or the
atomizer.
Water inside the unit may result in failure of the device.
5. Do not hit and do not throw the water tank. It can be damaged
which will result in water leakage. Do not use the unit in case the
tank is heavily hit.
Contact a maintenance service or maintenance and repair station
immediately.
6. Every day fill the tank with pure water and keep the unit clean.
4 www.timberk.com electric humidifier