Bonnet – FIAT Stilo User Manual

Page 93

Advertising
background image

92

SAFETY DEVICES

CORRECT USE OF THE CAR

W

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

CAR

MAINTENANCE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

BONNET

TO OPEN THE BONNET

Proceed as follows:
❒ pull lever A-fig. 118 in the direction of

the arrow;

❒ pull lever B-fig. 119 and lift the bon-

net.

IMPORTANT Bonnet raising is aided by
two side gas springs. Do not tamper with
these springs and guide the bonnet while
raising it.

IMPORTANT Before opening the bonnet,
check that windscreen wiper arms are not
lifted from the windscreen.

TO CLOSE THE BONNET

Lower the bonnet at approx. 20 cm from
the engine compartment and then let it
drop, ensuring that it is fully closed and
not just held in position by the safety
catch. If the bonnet does not close prop-
erly do not push it down but open it again
and repeat the above procedure. If the
bonnet is not shut properly, the warning
light

´ comes on together with the mes-

sage on the display (see section “Warning
lights and messages”).

IMPORTANT Always check that the bon-
net is closed properly to avoid its opening
while the car is travelling.

fig. 118

F0C0029m

fig. 119

F0C0383m

For safety reasons the bon-
net must be closed properly

to avoid its opening while the car is
travelling. Therefore, always check it
is properly closed and the catch en-
gaged. Should you notice that the
catch is not perfectly engaged when
travelling, stop the car immediately
and close the bonnet.

WARNING

This should only be done
when the car is stationary.

WARNING

Advertising