Acoustic Research ARHT8 - Manual

CAUTION!
DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire
extension cords or adapters. This surge protector is designed for indoor use
only. Install the surge protector away from heat emitting appliances such
as radiators or heat registers. DO NOT install where excessive moisture
is present. DO NOT plug extension cords into the surge protector. Never
install electrical or telephone wiring during a lightning storm. DO NOT
USE FOR MEDICAL OR OTHER LIFE SUPPORT EQUIPMENT OR OTHER
HIGH RISK ACTIVITIES. DO NOT USE IN DAMP AREAS OR NEAR
WATER RELATED APPLICATIONS SUCH AS AQUARIUMS, HOT TUBS,
ETC.
1. Plug the surge protector into a grounded 3-prong outlet only.
2. Plug all connected equipment directly into the surge protector.
3. Press the master power switch to turn on the surge protector.
ARHT8 User’s Guide
Connecting Equipment To Your
AR Surge Protector
Power Connections
RECEIVER
TV
VCR
DVD
AUDIO EQUIPMENT
GROUNDED
OUTLET
MASTER
POWER SWITCH
The USB Charge outlet on this charger is optimized for use with
certain types of mobile devices. As a result, the USB Charge outlet
may not charge all models of all brands of your mobile devices.
USB Charging
USB device USB cable
Indicator Lights
• The Protected light should be on when the power switch is turned on when the surge protector is plugged into
an outlet.
• The Grounded light should be on when the surge protector is plugged into an outlet. If the light does not
come on when you turn on the surge protector, you have a ground wiring problem and you should contact an
electrician to properly ground the outlet. Connecting your surge protector to an improperly grounded outlet will
void all Audiovox warranties.
If you are using a coax cable, pass the connection through the
protected coax jacks on your surge protector. Most TV/VCR
damage can be prevented if you connect the coax cable through
the surge protector.
1. Connect the Cable/Antenna line from your source to the
INPUT jack on the surge protector.
2. Connect the coax cable from the OUTPUT jack of the surge
protector to the device you want to protect.
Sat/Coax Cable Connections
CONNECT TO
DEVICE'S COAX
JACK
coax
cable
TV/VCR/CABLE DEVICE
CABLE/
ANTENNA
OUTLET
If you are using an Ethernet network data line, pass the
connection through the protected Ethernet jacks on your
surge protector. Most network card or modem damage can be
prevented if you connect the
CAT. 5 or CAT. 6 cable through the
surge protector.
1. Connect the CAT. 5 or CAT. 6 cable from your wall outlet to
the INPUT jack on the surge protector.
2. Connect a CAT. 5 or CAT. 6 cable into the OUTPUT jack on
the surge protector.
3. Connect the other end of the CAT. 5 or CAT. 6 cable to the
jack of the network card or modem you want to protect.
Ethernet Connections
CONNECT TO
DEVICE'S JACK
DEVICE
(network card, modem, etc.)
CAT. 5 or CAT. 6
WALL JACK
CAT. 5 or CAT. 6
cable