Acroprint TQ600M (software version 4.x and above) - Manual

24 Volt Switching Relay
Manufacturer: Honeywell
Mfg. P/N: RA89A1074
Tech Specs
Hydronic
10.2
5.1
10
6
61.2
30.6
24 vAC
SPST
2-3/8
5-1/4
4-1/4
Hydronic Heating
Type
Full Load Amps @120V
Full Load Amps @240vAC
Resistive Amps @ 120V
Resistive Amps @ 240V
Locked Rotor Amps @ 120V
Locked Rotor Amps @ 240V
Coil Volts
Switch Action
Depth (in)
Height (in)
Width (in)
Application
TQ600BC & TQ600M External Bell Connection
Please consult your local electrician for installation.
All wiring must comply with all local and national electrical codes,
ordinances, and regulations. Failure to comply could cause serious
electrical shock and damage to equipment that will void the warranty.
It is necessary to install a relay in order to control an External Signal Device such as a
bell, horn, buzzer or strobe. When a signal is activated the internal contacts close
completing the circuit. These internal contacts are “dry” and supply no voltage. Voltage
applied to these contacts must not exceed 30 volts. The relay activates the external
signal device.
A 24 Volt Switching Relay made by Honeywell (Acroprint p/n 01-0230-000) is available
from Acroprint (see below):
Page 1 of 5