SUUNTO X10 - Manual (Page 41)

40
The symbol options are:
You will navigate from the beginning or the active waypoint to the end of the
route. When you arrive at the waypoint, Suunto X10 will automatically activate the next
waypoint.
You will navigate in the reversed order, from the end or from the active waypoint
to the beginning of the route.
You will navigate to a chosen waypoint until you activate another waypoint or
change the navigation method.
A route is not activated. You will navigate to the first GPS position (Start) instead
of an actual route destination.
This symbol is displayed when you activate a single waypoint on the MyPoints
route. This navigation option is only available if you choose a waypoint from the
MyPoints route.
NOTE: In normal route navigation, the unit automatically
switches to the next waypoint when you arrive inside a 30-
meter radius of the waypoint or pass it at a distance further
than 100 meters of the perpendicular line to the route that
goes through the waypoint.
Changing the active waypoint
You can change the active waypoint in the Navigation data
display.
To change the active waypoint:
1.Press START/DATA to open the Navigation data display.
2.Select the desired waypoint with UP/DOWN.
3.Press ENTER to activate the selected waypoint. Suunto
X10 starts guiding you to this waypoint.