Herman Miller Setu Lounge Chair and Ottoman - Disassembly For Recycling - Manual

Z
© 2012 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Setu are among the registered trademarks of Herman Miller, Inc.
TM Sense, Setu, and Tu are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b5vn8 rev B.
1
Y
Setu
®
Disassembly for Recycling
Tools Required:
Power Driver Small Flathead
Screwdriver
Safety Glasses T-27 Torx Bit
(2.75” or longer)
2 lbs Hammer
Utility Knife Rubber Mallet
T-20 Torx Driver
Materials Identification and Segregation:
Disassembly Steps:
Where possible, plastic components are marked with ASTM recycling codes. Use
these codes to identify material type for recycling. Non marked components should
be treated as mixed plastic. Ferrous metals can be identified using a small magnet for
recycling. Non-ferrous metals should be separated and recycled separately.
2.1 Grasp and pull to remove
Casters from the Base. 1.1 Lay chair on back.
Caster