MSD 8366 GM Late Model HEI V8 Ext Coil Distributor Installation User Manual

Pro-billet late model gm distributor

Advertising
background image

Pro-Billet Late Model GM Distributor,

V8-PN 8366*, V6-PN 8367

Parts Included:

Replacement Parts:

1 - Distributor

V8 Cap - PN 8426

1 - Gear Lubricant

V8 Rotor - PN 8427

1- Gasket

Gear - PN 8531

Figure 1 Marking the Distributor Location.

These Pro-Billet Distributors are designed as direct replacements for most GM V8 and 4.3L V6 engines

with factory fuel injection systems and a remote, dual connector coil.

REMOVAL

1. Remove the existing distributor cap without

disconnecting any spark plug wires.

2. With the cap off, turn the engine over until the rotor is

aimed at a fixed point on the engine or firewall. Note

this position by making a mark (Figure 1).

3. Place the distributor cap back on and note which

plug wire the rotor is pointing at. Mark the spark plug

wires and remove the cap.

4. Disconnect the two connectors from the distributor’s

ignition module.

5. Loosen the distributor hold-down clamp and slide it

out of the way.

6. Lift the distributor out of the engine. Note that the rotor

rotates as you lift it out. This is due to the helical cut

gear and should be taken into consideration when

installing the new distributor.

INSTALLATION

Note: There are two O-Ring grooves on the housing. The supplied O-rings can only be used if the

block has been modified as shown in Figure 2.

1. Remove the cap from the MSD distributor. Install the new gasket on the housing.

2. Apply a liberal amount of the supplied break-in lubricant to the distributor gear.

3. Install the distributor making sure that the rotor comes to rest at the fixed mark. If the distributor

will not fully seat you may need to rotate the oil pump shaft.

4. With the rotor in the correct position and the distributor fully seated, install the distributor clamp

and tighten it.

5. Connect the two wiring harnesses.

WARNING: During installation disconnect the battery cables. When disconnecting the

battery, always remove the negative cable first and install it last.

* The PN 8366, V8 Distributor is U.L. approved for marine applications.

M S D  

•   W W W . M S D P E R F O R M A N C E . C O M   •   ( 9 1 5 )   8 5 7 - 5 2 0 0   •   F A X   ( 9 1 5 )   8 5 7 - 3 3 4 4

ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered

in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product

will help if there is ever a warranty issue with your product and helps the MSD R&D team create

new products that you ask for! Go to www.msdperformance.com/registration.

Advertising
This manual is related to the following products: