MSD 7530T Programmable Digital-7 Ignition Control Installation - Manual (Page 4)

4 INSTALLATION INSTRUCTIONS
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
PRO-DATA+
INSTALLATION OF THE PRO-DATA+ SOFTWARE
1. Insert the installation CD into your CD drive.
2. In Windows, click on Start then select Run.
3. In the box type, “A:Setup” and press Enter (or whatever disk drive you are using).
4. The screen will walk you through several steps.
5. Once loaded, your monitor will have an MSD Graph View logo. Click on it to open the software.
6. A program will open. Go to the upper left corner of the screen and click on File, then Open.
7. This will open a menu of part numbers. Select “7530T”.
8. This will open another menu of versions. Highlight and open the “7530Tvxx.IGN” (xx determines
the versions, such as 22). This will open the Pro-Data+ software for the Programmable Digital-7
Ignition.
SAVES AND TRANSFERS
Whenever a change is made to a program, it either must be saved to a file in your PC or it needs to
be transferred to the ignition. You will notice that whenever you make a change to a program, the
bullet next to the modified value will turn red. It will remain red until you save it to a file or to the MSD.
There are two ways to save your files.
Figure 1 Wiring the Programmable Digital-7 Ignition.