MSD 6302 DIS Dual Coil Ignitor, 2 Channel Installation - Manual

M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
Dual Ignition Coil Ignitor
PN 6302
Parts Included:
1 – Dual Ignition Coil Ignitor
1 – Parts Bag
The MSD Dual Ignition Coil Ignitor allows for the installation of an MSD DIS-2 Series Ignition Control and
MSD Coils on vehicles with factory transistorized/driver style coils. It achieves this by inverting the logic
signal from the ECU and creating a high current output to drive an inductive coil, or points input of an
MSD Ignition Box.
Note: There are a number of different applications that can use the PN 6302. These instructions illustrate
an installation on a 4-cylinder with 2 wasted spark coils. It is recommended to have the wiring
schematic of your vehicle prior to installation.
MouNtINg
The Dual Ignition Coil Ignitor is designed to be mounted under the hood. The circuits are potted in
polyurethane for water resistance and vibration protection. Position the unit away from excessive heat
sources and mark the location of the three mounting holes. Use a 5/32” bit to drill the holes and secure
the unit with the supplied screws.
WIRINg
The Dual Ignition Coil Ignitor comes with both male and female bullet terminals installed on the harness.
These terminals are designed to plug directly into the harness of an MSD DIS-2 Ignition, color-to-color. The
ring lugs supplied in the parts bag install on the black wires and are to be connected to a good chassis
ground.
WIRING
WHITE Factory ECU Signal A.
GREEN Factory ECU Signal B.
BROWN/WHITE Output to DIS A.
BROWN/GREEN Output to DIS B.
BLACK Chassis ground.
WHITE
BROWN/WHITE
GREEN
BROWN/GREEN
BLACK
PN 6302
GOOD CHASSIS
GROUND