Shogun Motorsports Kawasaki ZX10R (08-10) Frame Slider User Manual
Page 4
10.
On this particular bike because you are opening a hole up on a radius the shape of the hole will
be oblong. We used the right side puck to make a template on the left side. We put a bolt
though the puck and lightly threaded into the bike. A pencil was then used to draw our diameter
of desired shaped hole. A flexible hole template can also be used for the same purpose.
11.
For this application we used a drummel tool with a sanding roll to open up the hole little by
little.
MAKE SURE YOU WEAR PROTECTIVE GOGGLES AND GLOVES
As you cut and open the hole
to your scribe marks keep checking that the hole is lining up with your puck dimensions or the
spot tool. If for some reason you cut too big and you want to close the gap around the puck we
use windscreen trim or window seal with 3m adhesive. Trim the seal to fit the hole and get the
seam to meet under the puck so it is less visible.
12.
Mount left side puck with 99-HB-SH10125090 Socket Cap 10 X 1.25 X 90 Main Engine Stud and
torque down to OEM torque specifications.
13.
Mount left side panel.
READ CAREFULLY
Shogun cannot guarantee that they will protect your motorcycle from any extent of damage.
Shogun frame sliders are really meant to help possibly save the frame from damage in the
event of a crash. Because Shogun frame slider products have been successful in saving cases,
bodywork, levers and so on in the past, customers just assume sometimes you can put the
product on and no damage will happen. The fact is, some crashes result in little or no damage
to the motorcycle and some bikes are destroyed. It’s kind of like a bumper on a car sometimes
it works sometimes it doesn’t, it really depends on all the different forces applied during the