Shogun Motorsports Honda CBR600RR (07-12) Frame Slider User Manual

Shogun Motorsports For motorcycles

Advertising
background image

HondaCBR600RR (07-12) Frame Slider

Installation Instructions

Part Numbers: 750-3320, 750-3329, 750-3349,

750-3340, 755-3349& 850-3340

MADE IN THE USA!
Carefully read instructions in their entirety before the install

Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from factory service manual, safety goggles and gloves.The motorcycle
must be in a fixed secure position before the install process begins.

DO NOT

remove both engine studs

at the same time.

Shogun is not responsible for any part of your motorcycle for any reason.

Precisely

measure location of cut and if in doubt at any point please call us before the install process has begun.

Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY

Price each

Part Numbers

Descriptions


1

$20.00

99-FS-750-3329-L

Black Left Side Puck

1

$20.00

99-FS-750-3320-L

White Left Side Puck

1

$25.00

99-FS-850-3320-L

Chrome Left Side Puck

1

$5.50

99-HB-SH12125090

Socket Cap 12 X 1.25 X 90 Main Engine Stud


Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1

$20.00

99-FS-750-3329-R

Black Right Side Puck

1

$20.00

99-FS-750-3320-R

White Right Side Puck

1

$25.00

99-FS-850-3320-R

Chrome Right Side Puck

1

$5.50

99-HB-SH12125090

Socket Cap 12 X 1.25 X 90 Main Engine Stud


Frame Sliders: Left longer than right, bolts same left and right 12 X 1.25 X 90mm.

Installation Steps apply to left and right hand side.

1.

Some photos in this section are used for

illustration

examples only. It is up to you how you

decide to cut your motorcycles bodywork to accept the frame slider there are many different
ways customers go through this process.

Shogun is not responsible for any part of your

motorcycle for any reason.

Precisely measure location of cut and if in doubt at any point please

call us before the install process has begun.

Professional installation is recommended.

Always

use proper safety measures during the install of this product. Do not try to install this product
without proper tools, recently calibrated torque wrench, correct torque specifications from
factory service manual,

safety goggles and gloves.

2.

Locating and cutting the body. This is a simple illustration of how most of us install the product

here. It takes a bit longer but our end results have been more consistent with a better overall fit
and finish. We start with (99-SPOT-1212560) Shogun Spot tool. It’s nothing special just a 12mm
socket cap bolt with a 1.25 pitch that we cut the head off of and sharpen to a point. You can
purchase the tool for $12.99 or go to your local hardware store and make your own. Keep in

Advertising