Shogun Motorsports Suzuki GSX1300R (99-07) Frame Slider User Manual

Shogun Motorsports For motorcycles

Advertising
background image

Suzuki GSX1300R (99-07) Frame Slider

Installation Instructions

Part Numbers: 750-5219, 755-5219, 750-5210,

850-5210C

MADE IN THE USA!
Carefully read instructions in their entirety before the install

Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from factory service manual, safety goggles and gloves. The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time.

Shogun is not responsible for any part of your motorcycle for any reason.

Precisely

measure location of cut and if in doubt at any point please call us before the install process has begun.

Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY

Price each

Part Numbers

Descriptions


1

$20.00

99-FS-750-5219-L

Black Left Side Puck

1

$20.00

99-FS-750-5210-L

White Left Side Puck

1

$30.00

99-FS-850-5210-L

Polished Billet Left Side Puck

1

$3.50

99-HB-SH10125090

Socket Cap 10 X 1.25 X 90 Main Engine Stud


Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1

$20.00

99-FS-750-5219-R

Black Right Side Puck

1

$20.00

99-FS-750-5210-R

White Right Side Puck

1

$30.00

99-FS-850-5210-R

Polished Billet Right Side Puck

1

$3.50

99-HB-SH10125100

Socket Cap 10 X 1.25 X 100 Main Engine Stud


Frame Sliders: Left and right hand sliders are the same size. The base is narrower on the left hand slider.
In order to identify the sliders match the back side of the sliders up to each other. The skinnier base is
intended for the left hand side.

Installation Steps:

1.

Some photos in this section are used for

illustration

examples only. It is up to you how you

decide to cut your motorcycles bodywork to accept the frame slider there are many different
ways customers go through this process.

Shogun is not responsible for any part of your

motorcycle for any reason.

Precisely measure location of cut and if in doubt at any point please

call us before the install process has begun.

Professional installation is recommended.

Always

use proper safety measures during the install of this product. Do not try to install this product
without proper tools, recently calibrated torque wrench, correct torque specifications from
factory service manual,

safety goggles and gloves.

2.

Body Prep. Use masking tape to completely mask off the area on the body where you will be

working. We usually will tape off approximately 6 to 8 inches around the though hole area and
any other edges that could get bumped or scratched while working. Tip: In some locations you
may want to double up the thickness of the masking take to give extra protection.

Advertising