TROY Group Hewlett-Packard LaserJet 3015 Font Card Kit Installation Guide - Manual

Installation Guide
Document #50-70417-001 Rev. A
Page 1 of 1
Hewlett-Packard 3015 Printers:
IMPORTANT: Ensure the printer power is switched OFF,
and then disconnect the printer power cord
from the AC outlet.
1. Slide the right-side rear panel toward the rear of the printer.
Figure 1
2. Insert the font card into the rear USB slot (slot nearest the interior of the printer). Ensure the font card is
fully inserted in the card slot.
Figure 2
3. Replace the printer panel. Then reconnect the printer power cord and printer data cable.
4. Refer to the TROY Quick-Start Guide (provided with your TROY Font Card Solution) for instructions on
installing the required TROY software and support files.
NOTE: If assistance is required for installing the font card, please call TROY Technical Support
at (800) 332-6427. Customers outside the United States, please call (304) 232-0899.