TROY Group MICR_IRD 3005 Security Printing Solutions User’s Guide - Manual (Page 155)

Appendix IRD 9050 1
UP
Printer Setup Guidelines
S Security Printing Solutions User’s Guide -- 50-70410-002 Rev. A
A-1
Introduction
Installing 1 UP
IRD Forms
Configuring
the TROY IRD
9050 1
UP
Printer for
IRD Forms
Thank you for purchasing your TROY IRD 9050 1
UP
series printing solution. You have chosen the highest
quality IRD (Image Replacement Document) printing solution available today that offers convenience, flexibility,
security, and precision for printing high-quality IRD forms. The TROY IRD 9050 1
UP series printers consist of a
TROY MICR 9050 series printer combined with a specially redesigned TROY IRD duplexer and two TROY
IRD paper trays designed to accommodate both forward and return single IRD forms. The Secure EX version
includes the addition of paper tray locks, a printing enable/disable lock switch, and additional security firmware
features designed to enhance printing security.
The IRD 9050 1 UP paper trays can accommodate only forward and return single IRD forms. When loading IRD
forms into the paper tray, open the paper guides to slightly larger than the form dimensions. After the forms are
placed in the tray, close the paper guides just enough to prevent the forms from moving in any direction, but not
tight enough to pinch the forms and interfere with the printer’s ability to pick the forms from the tray.
IMPORTANT: IRD forms must be loaded into the printer with the bottom edge of the document (the edge where the
MICR line is printed) oriented toward the front of the printer paper tray (see page A-4 for details). Failure to load
the return IRDs as described will cause the IRD forms to jam in the printer.
NOTE: To print documents using standard size paper, TROY IRD 9050 1 UP series printers must have the 100-sheet
multipurpose tray installed.
Because the custom 1 UP paper tray guides can be set to accommodate either forward or return-size IRD forms, the
printer’s paper size settings must be set (via the printer control panel) to match the type of IRD form (forward or
return) loaded into each paper tray. Refer to table below for the appropriate IRD paper dimensions. Refer to the
instructions on the next page for configuring the printer.
IMPORTANT: Specifying the true size of the IRD forms in the printer setup will cause the printer to either refuse to
duplex or the forms may jam in the duplexer section of the printer. Always use the paper dimensions listed in the
table above and not the true dimensions of the IRD forms.
NOTE: Information on formatting and printing of image replacement documents (IRDs) is described in the
American National Standard for Financial Services X9. 100-140-2004 Specification and is available on the ANSI
(American National Standards Institute) web site (
www.ansi.org ).
IRD Form Width (Y-Dimension) Height (X-Dimension)
Forward IRD 8.50” 7.17”
Return IRD 8.50” 7.80”