M-AUDIO NRV10 - Manual (Page 20)

NRV10 User Guide
|
20
< Set the Phones Source switch (29) to Monitor
< Setting the Pre/Post-EQ switch (26) to Pre-EQ will send the NRV10’s input signals to the DAW before the
channel EQs. Setting it to Post-EQ will send the signals to the DAW after the EQ.
< Set your DAW Software Monitoring to on if you wish to hear the return of your tracks from your DAW.
Set it to off if you want to listen to the channel inputs.
Important: When using this monitoring scheme, be careful not to create a feedback loop. When the Channel
Source switch (6) is in the FW (down) position, do not move the Pre/post-EQ switch (26) to the Post-EQ
(down) position. Doing so will send the post-EQ signal to the DAW, while returning the same signal to the mixer
before the EQ, resulting in an audible feedback loop, which can damage your hearing as well as your equipment.
Returning Tracks from Your DAW
After you’re done recording, select any of the NRV10’s outputs 1 through 8 as they appear in your DAW as the output
for each channel you wish to route to the NRV10. Move the Channel Source button (6) to the FW (down) position for
the input channel(s) you have routed to.
The Digital Effects Processor
11
T
he NRV10 gives you an integrated digital effect processor, offering 16 presets with 16 settings per preset, for a total of 256
possible effects. Use the Aux 2 send control to send input signal to the effects processor.
The following programs are available:
1. Short Room
2. Room
3. Small Hall
4. Large Hall
5. Short Plate
6. Vocal Plate
7. Cathedral
8. Gated Reverb
9. Mono Echo
10. Stereo Echo
11. Chorus Medium
12. Chorus Deep
13. Flange Medium
14. Echo + Vocal Plate
15. Chorus + Hall Reverb
16. Flange + Delay