Atdec Visidec VF-AT-NP Installation manual - Manual

visidec
visidec
Focus Notebook Mount
Installation Instructions
Component Checklist
Desk Clamp
IMPORTANT INFORMATION
! IMPORTANT - Install Visidec Focus Notebook Mount as per Installation Instructions.
! This product is designed to be used in conjunction with an external keyboard and mouse.
! Visidec Focus Notebook Mount supports Notebooks up to 18”, weighing up to 8kg (17
1 /
2
lbs).
! The Manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
VF-AT-NP
Step 2. Desk Mounting (Bolt Through or Desk Clamp)
Notebook Tray and
Arm Assembly
Step 6. Cable Management - Ensure Arm is fully extended.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 06.09.12 ©
Installation Complete
Your Visidec Focus Notebook Mount installation is complete and ready for use.
Pole Assembly
IMPORTANT:
The “User Operating
Card” must be left with
Visidec Focus Articulated
Arm once installed.
Hardware
Desk Clamp
Bracket
Pressure
Plate
M8 Desk
Clamp Screw
5mm Allen
Key
Primary Arm
Cable Cover
Secondary Arm
Cable Cover
Pole Top
Cap
Pole Base
Cable Clip
M8x30mm
Screw
Steel Washer Cable Balls (x2)
Pole Assembly
Pole Base
9mm ( 3 /
8
”) Hole
Steel Washer
M8 Desk Clamp Screw
(found in the Desk
Clamp Box) 5mm Allen Key
Tighten Firmly
Bottom
Option A - Bolt Through
Drill a 9mm ( 3 /
8
”) hole in the Work
Surface at the desired position and
assemble as shown.
NOTE: It is recommended that
the Pole Assembly be mounted
towards the rear edge of the
Work Surface.
Work Surface
(rear edge)
Self Adhesive
Hook-and-Loop
Fasteners (x4 sets)
TIP: If the Visidec Focus
Arm is to be used in a
multi-user environment,
use the supplied Cable
Clip to secure the cables
to the Pole.
Cable
Clip
B. Push in...
C. Then push up
Cable
Balls (x2) Insert Secondary
Arm Cable Cover*
Insert Primary
Arm Cable Cover*
*To insert Cable Covers:
A. Insert tabs...
TOOLS REQUIRED:
•Power Drill
•9mm (
3 /
8
”) Drill Bit
Step 7. Notebook Tray Alignment
Insert cables into
slot, using Cable
Balls to hold them
in place.
Route the Cables underneath the Arms,
inserting the Primary and Secondary
Arm Cable Covers to hold the Cables in place.
TIP: Leave enough slack in the cables
at the joints to allow full movement.
Set the height and position of the Notebook Tray desired.
The height can be adjusted by unlocking the Handgrip (see Steps 3, D and E).
For the optimal position of your display, refer to the Ergonomic Guidelines in your ‘User Operating Card’.
±5° Horizontal
Adjustment
Adjust the tilt angle of the Notebook
Tray as desired, locking it in
position using the 5mm Allen
Key stored in the Pole Top Cap.
25° TILT
LOOSEN
TIGHTEN