Atdec Visidec VF-AT-NK Installation manual - Manual

visidec
visidec
Focus Notebook Mount Accessory
Installation Instructions
Component Checklist
IMPORTANT INFORMATION
! IMPORTANT - Install Visidec Focus Notebook Mount as per Installation Instructions.
! This product is deisgned to be used in conjuction with an external keyboard and mouse.
! To be used with existing Visidec Focus Mount.
! Visidec Focus Notebook Mount supports Notebooks up to 18”, weighing up to 8kg (17
1 /
2
lbs).
! The Manufacturer accepts no responsibility for incorrect installation.
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
VF-AT-NK
Step 2. Remove existing Arm and Monitor from Visidec Pole (ensure monitor cables are unplugged)
Notebook Tray and
Arm Assembly
Step 7. Cable Management - Ensure Arm is fully extended.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 06.09.12 ©
Installation Complete
Your Visidec Focus Notebook Mount installation is complete and ready for use.
IMPORTANT:
The “User Operating
Card” must be left with
Visidec Focus Articulated
Arm once installed.
Hardware
Primary Arm
Cable Cover
Secondary Arm
Cable Cover
Self Adhesive
Hook-and-Loop
Fasteners (x4 sets)
A. Insert tabs...
B. Push in...
C. Then push up
Insert Secondary
Arm Cable Cover*
Insert Primary
Arm Cable Cover*
*To insert Cable Covers:
TIP: Leave enough slack in
the cables at the joints to
allow full movement.
Route the Cables underneath the Arms,
inserting the Primary and Secondary
Arm Cable Covers to hold the Cables in place.
Hand Grip
Whilst supporting the weight of the
Monitor, unlock the Hand Grip. Lift the Monitor and Focus Arm,
removing them both from the
Visidec Pole.
Hand
Grip
Monitor
Visidec Pole
Remove the Pole Top Cap and
5mm Allen Key from the Visidec
Pole.
Visidec
Pole
Pole Top
Cap
5mm Allen
Key
Step 8. Display Alignment
Set the height and position of the Notebook Tray and Monitor as desired.
The height can be adjusted by unlocking the Handgrips (see Steps 3, D and E).
For the optimal position of your display, refer to the Ergonomic Guidelines in your ‘User Operating Card’.
UNLOCK
UP
UP
±5° Horizontal
Adjustment
95° Portrait/
Landscape Rotation
Adjust the tilt angle of the Notebook
Tray as desired, locking it in
position using the 5mm Allen
Key stored in the Pole Top Cap.
25° TILT
LOOSEN
TIGHTEN