Atdec Telehook TH-1040-CT-B2B Installation manual - Manual

! This product is to be installed in conjunction with TH-1040-CTS and TH-1040-CTL Ceiling Mounts only.
Component Checklist
Mount Head
Accessory
VESA Plate
REMOVE
Installation Instructions TH-1040-CT-B2B
Back to Back Accessory for TH-1040-CTS and TH-1040-CTL
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received all parts against the Component Checklist and Hardware above.
Step 2. Remove Back of Existing Mount Head
Step 3. Install Mount Head Accessory
! IMPORTANT - Install Telehook 1040 Back to Back Accessory as per Installation Instructions.
Hardware
! The manufacturer accepts no responsibility for incorrect installation.
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 21.06.10 ©
Installation Complete
Remove back half of the existing
Mount Head by removing
Socket Cap Screws (x2).
Attach the Mount Head
Accessory with the Socket
Cap Screws (x2).
Tighten screws firmly
and equally.
Back
5mm Allen Key
Socket Cap Screw
Fully installed TH-1040-CTS or
TH-1040-CTL (VESA Plate removed).
5mm Allen Key
Mount Head
Accessory
Socket Cap Screw
Socket Cap Screw
M4x16/25mm
(x4 each)
M5x16/25mm
(x4 each)
M6x16/30mm
(x4 each)
Refer to TH-1040-CTS/TH-1040-CTL Installation Instructions, Step 8. Attach VESA Plate to Display.
M4/M5 Washer
(x4 each)
M4/5 Spacer (x4)
M6/8 Spacer (x4)
Security Screw
Display
Mounting
Screws
5mm/2mm
Allen Keys
(x1 each)
Use the 5mm Allen Key supplied.
Keep Socket Cap Screws for Step 3.
Socket Cap
Screw
Tension Tool