B&W Trailer Hitches RVXA3120 - Manual

B&W Trailer Hitches
1216 HWY 224 / PO Box 186
Humboldt, KS 66748
P:620.473.3664
F:620.473.3766
Installation Instructions
NOTE:
We recommend reading instructions before beginning the installation.
Call or Email us for
Installation Support
[email protected]
www.turnoverball.com
Model RVXA3120
Copyright 2013, B&W Custom Truck Beds, Inc. ALL RIGHTS RESERVED RVXA3120 06 24 2013
RAM RV FOOT, BED SUPPORT KIT
PREPARING TO INSTALL
NOTE: Remove all parts from the packaging and
familiarize yourself with all the parts required. Use the
parts list to verify that all the parts and hardware are
present.
Remove Base pads. If present, Remove the rubber
pads installed underneath the Companion base.
Install foot pads: If your bed has a spray in bed liner
the foot pads are not required. Place four foot pads
on each foot, two pads on either end, see figure A1.
These pads will protect your bed from the sharp edges
of the steel feet.
INSTALL FEET
Attach Feet: Each foot can be attached by
"wrapping" the hemmed edge of the foot around the
outer flange of the base feet, see figure B1.
Install hardware: Attach each foot to the
companion base with two locking straps, as shown in
figure B2. Secure the feet and the locking strap to
the base with the 5/16" carriage bolts, washers, lock
washers, and nuts provided with the kit.
NOTE: It is normal for the locking straps to deform
when the 5/16" hardware is tightend.
Follow all warnings and methods described in the
companion installation instructions (model RVK3000).
Copies of these documents can be found at our web
site: www.turnoverball.com or by calling
620−473−3664.
PARTS LIST
QTY DESCRIPTION ITEM
2 Ram RV Foot 1
4 Locking Strap 2
4 5
16
" Carriage Bolt 3
4 5
16
" Flat Washer 4
4 5
16
" Lock Washer 5
4 5
16
" Finish Nut 6
8 Foot Pad (Not Shown) 7
FIGURE B1
Figure B2
Figure A1
6
5
4
2
1
3
HEMMED
EDGE
FOOT
LOCKING
STRAP
FOOT FOOT
FOOT PADS