Shindy 17-662_B Clutch Master Cylinder Kits - Manual

NISSIN CLUTCH MASTER CYLINDER KIT
PART # 17-661/B (5/8" Piston diameter)
PART # 17-662/B (14mm Piston diameter)
**All kits are inspected for quality before it ships by the manufacturer.
**Air-bleeding is a difficult process. Because each kit is thoroughly examined for anti-leaking,
each kit is assured that it is capable of bleeding air completely, if done correctly.
Information:
-Fits 7/8" diameter handlebars
-Use M10 x P1.25 Banjo-Bolt
-Lever angle is adjustable to 5 positions
-Use DOT 4 polyglycol ether based fluid and Do NOT use DOT 5 brake
fluid or silicone based fluid
Instructions:
*Refer to illustration below before installation
1. Release all clutch fluid.
2. Remove stock master cylinder assembly.
3. Install new master cylinder assembly to the handlebar. Connect clutch hose with
M10 x P1.25 banjo bolt. Always use a new gasket.
4. Use the supplied bracket with the mirror (or M10 x P1.25 bolt), and fix the reservoir
tank on the bracket.
5. Fill with new clutch fluid.
6. Bleed the air continuously until all the air is completely released. Make sure that air
bleeding is also done in the rubber hose between the reservoir and master cylinder.
Any air left in the whole kit may result in poor clutch function and may cause an
accident.
7. Connect the clutch switch connector to the new master cylinder assembly.
8. Adjust the angle of the lever for best position.
9. Make sure that the lever does not shift around, that the clutch hose and banjo bolt
area is not leaking, and nothing is in the way of your clutch when steering.