Shindy 17-666G_K Radial Clutch Master Cylinder Kits User Manual

Shindy For motorcycles

Advertising
background image

NISSIN RADIAL CLUTCH MASTER CYLINDER KIT

PART # 17-666G/K (19mm Piston)

**All kits are inspected for quality before it ships by the manufacturer.
**Air-bleeding is a difficult process. Because each kit is thoroughly examined for anti-leaking,
each kit is assured that it is capable of bleeding air completely, if done correctly.

Information:

-Fits 7/8" diameter handlebars

-Use M10 x P1.25 Banjo-Bolt

-Lever angle is adjustable to 5 positions

-This kit will fit the standard 14mm diameter master cylinder.

-Use DOT 4 polyglycol ether based fluid and Do NOT use DOT 5 brake fluid or silicone

based fluid


Parts

Quantity

1

Radial Clutch Master Cylinder

1

2

Reservoir Tank

1

3

Hose

1

4

Hose Clamp

2

5

Reservoir bolt (M6)

1

Parts

Quantity

6

Tank Fixing nut (M6)

1

7

Reservoir Bracket

1

8

Mirror Holder

1

9

Clamp

1

10

Mirror Hole Bolt (M10)

1

Instructions:

1. Release all clutch fluid.

2. Remove stock master cylinder assembly.

3. Install new master cylinder using mirror holder (or clamp) and Allen cap screw.

4. When installing the mirror holder (or clamp), tighten the top bolt using 9-12Nm

torque. Make sure it is in a good position, and tighten the bottom bolt.

5. Connect the clutch switch harness to the new master cylinder assembly.

6. Install the tank assembly using the bracket, supplied nut and supplied bolt.

7. If attaching a mirror, attach onto the mirror holder.

8. Using a new gasket, attach the clutch hose to the new master cylinder.

9. Remove reservoir tank cap and fill the reservoir tank with clutch fluid.

10. Bleed the air continuously until all the air is completely released. Make sure that air

bleeding is also done in the rubber hose between the reservoir and master cylinder. Any

air left in the whole kit may result in poor cluth function and may cause an accident.

11. When air bleeding is finished, attach reservoir tank cap and tighten the air bleeder

using 4-7Nm torque.

IMPORTANT: Shindy Products, Inc. cannot be held liable for any damage to the product, motorcycle or
persons and property caused by failure to follow the mounting and maintenance instructions exactly.

SHINDY PRODUCTS, INC.

1566 CENTRE POINTE DR.

MILPITAS, CA 95035

Advertising