Baron Chrome Shop_LAYDOWN LICENSE MOUNT - Honda VTX 1300R_1800R User Manual
Baron For motorcycles
Page: 1
BA-3165-01
Lay Down License Mount Assembly
Honda VTX1800 Retro
Revision: 1.1 - 02/23/2010
INCLUDED IN THE KIT:
(3) M6x10 Flathead Screws
(4) M5x10 Flathead Screws
(1) Chrome Backing Plate
(1) Chrome License Frame
INSTRUCTIONS:
Note: We recommend the use of Loctite on all fasteners and mounting hardware
Remove stock license holder from rear fender.
Install chrome backing plate with supplied M6 flathead screws into stock holes. Install with open edge down
so light from the tail lamp will illuminate license plate.
Check the fit of your license plate and trim as necessary.
Install license plate frame with supplied M5 flathead screw.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive
Huntington Beach, CA 92649
(925)583-2499 - Ph.
(714)901-0520 - Fax
www.baronscustom.com