Snap-On 5000-3 - Manual (Page 46)

CALIBRATION CHAPTER 5
WARNING
Always position the 40" arm over the front of the stand as shown. Never extend the test arm
behind the stand because the stand will tip over when weights are applied.
The 40" test arm is coupled to the 2000-13-02, 1000 ft. lb., and 2000-14-02, 2000 ft. lb.
transducers using a 1-1/4" drive adapter plate.
1. Remove the internal drive adapter plate and bottom plate from the transducer using the torque
wrench, ratchet head and 3/8-3/8 hex bit or 3/4" open-end adapter supplied.
2. Remove separated adapter from calibration block.
3. Attach transducer to the calibration block so that red mark on transducer lines up with white dot in
left bottom corner on calibration block. Tighten six 1/2"-13 hex head bolts to 75 ft. lb/ torque.
4. Attach the 1-1/4" drive adapter plate using six 1/2"x13 hex head bolts, each torqued to 75 ft. lb.
using the torque wrench, and 3/4” open end adapter, supplied.
5. After calibration, re-install the internal drive plate and bottom plate using appropriate 1/2"x13
screws, torquing them to 75 ft lb. Also re-install the separated adapter to the calibration block.
Appropriate hangers and weights are listed in the calibration checkpoint table in this chapter.
Notice that the weight of the hanger is included in all measurements. The hanger must be removed
to set ZERO tare on the SURETEST Base Unit.
4-in-1 Transducer Mounting Detail for Calibration
The 4-in-1 transducer mounts upright with integral transducers in the horizontal position. This
transducer may be mounted to a
• Wall using four 1/4" bolts torqued to 10 ft. lb., or
• Sturdy table using a right angle bracket. Refer to Figure 5-3.
Figure 5-3: 4-in-1 Transducer Mounting Detail
5-3