Speedhut 1994-2004 Ford Mustang Gauge Pod - Manual

Please contact Speedhut service department If you have a problem with this Product.
Speedhut Inc. 165 North 1330 West B2, Orem, Utah 84057 | [email protected] | (801) 221-1460 (9am - 5pm MST) | www.Speedhut.com
Installation Instructions: Ford Mustang 94-00 - Gauge Pod
Please contact Speedhut service department If you have a problem with this Product.
Speedhut Inc. 165 North 1330 West B2, Orem, Utah 84057 | [email protected] | (801) 221-1460 (9am - 5pm MST) | www.Speedhut.com
Installation Instructions: Ford Mustang 94-00 - Gauge Pod
Fig. 1 -
Short Bracket
Fig. 2 -
Long Bracket
Fig. 1 -
Short Bracket Fig. 2 -
Long Bracket
Models #10003 and 10005 (Brackets)
NOTE: Gauge bezel can be painted using a plastic safe paint.
1. Remove two screws in top of factory bezel. Use small screwdriver in the slotted area of the light switch knob to release tension on spring
clip while pulling forward to remove knob.
2. Pull forward on bezel from the inside bottom, detaching clips from the dash.
3. Install aluminum brackets as shown in Figs. 1 and 2.
4. Place new gauge bezel in dash as a test fit. Adjust brackets so that screw holes align. Brackets can be rotated or bent to align holes.
5. Once brackets are aligned, remove new gauge bezel and install gauges per manufacturer’s instructions (gauges are press fit).
Models #10003 and 10005 (Brackets)
NOTE: Gauge bezel can be painted using a plastic safe paint.
1. Remove two screws in top of factory bezel. Use small screwdriver in the slotted area of the light switch knob to release tension on spring
clip while pulling forward to remove knob.
2. Pull forward on bezel from the inside bottom, detaching clips from the dash.
3. Install aluminum brackets as shown in Figs. 1 and 2.
4. Place new gauge bezel in dash as a test fit. Adjust brackets so that screw holes align. Brackets can be rotated or bent to align holes.
5. Once brackets are aligned, remove new gauge bezel and install gauges per manufacturer’s instructions (gauges are press fit).