Wearwell 560 ERGODECK CABLE BRIDGE - CORNER - Installation Guide User Manual

Instruction sheet

Advertising
background image

INSTRUCTION

SHEET

Create 1-2” channel
between ErgoDeck®
floor tiles.

Lay the assembled
bridge over the channel.

Route cables/wires.

(optional) Anchor bridge
to tiles with 12 - ¾”
metal screws.

Wearwell, Inc. • 199 Threet Industrial Road • Smyrna • Tennessee • 37167 • Phone: 1.800.264.3030 Fax: 615.255.4428 • www.wearwell.com

Straight Kit - 560.78x18x36BLYL

Contents:

(4) yellow 18” side ramps
(2) 6" wide blue tiles

INSTALLATION

ERGODECK® CABLE BRIDGE KIT ASSEMBLY

1

2

3

4

Assembled Dimensions:
15” wide x 15” long

Corner Kit - 560.78x15x15BLYL

Contents:

(1) yellow inside corner ramp

(1) yellow outside corner ramp

(2) yellow side ramps
(2) 6" wide blue tiles

1

3

Arrange all components upside down in configuration shown
below, paying particular attention to the placement of all tabs

2

Connect tabs to corresponding rods on 2 blue center tiles

Connect end tabs to corresponding end rods to join 3 outside
ramp components

Lay inside tabs of outside corner section and inside corner
over corresponding rods of blue center tiles and connect.

4

NOTE: Use firm pressure or a rubber mallet to connect.
You will hear/feel a “click” when connectors are fully engaged.

NOTE: Use firm pressure or a rubber mallet to connect.
You will hear/feel a “click” when connectors are fully engaged.

1

3

Arrange all components upside down in configuration shown
below, paying particular attention to the placement of all tabs

2

Connect tabs to corresponding rods on 2 blue center tiles

Connect end tabs to corresponding end rods on both sections
of side ramps

Lay inside tabs of side ramps over corresponding rods of blue
center tiles and connect

4

3

2

2

3

4

4

Assembled Dimensions: 18” wide x 36” long

1

1

3

3

Advertising