American Car Craft Corvette Stingray Hood Vent Grille Laser Mesh Polished 2014+ C7 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C7 CORVETTE STINGRAY – HOOD VENT GRILLE LASER MESH
PART #053012
PARTS INCLUDED:
1-Stainless steel hood vent grill
1-Packet of adhesive promoter
1-Small scotch pad
1. Open the hood and remove the black plastic vent shroud using a T15 torch driver to remove the two screws
securing it to the hood. Once the screws are removed simply unsnap the shroud from the hood
2. Your new grill comes to you flat and will need you to bend the tabs along the sides so that the attachment tap
will face towards the center of the grill.
3. Set the grill over the hood vent opening so you can bend the tabs to the correct angle and also to get yourself
acquainted with just how it is intended to fit. You may need to tweak the shape a little so as to allow the grill to
sit nice and flat to the opening eliminating any wave in the grill.