American Car Craft Corvette Hood Panel Badge C6 Crossed Flags for factory hood pad 2005-2013 C6 all User Manual
American car craft instructions
AMERICAN CAR CRAFT INSTRUCTIONS
C6 Corvette Hood Panel Badge (2005-2013 Factory Hood Panel Only)
PART #043113
PARTS INCLUDED:
1- C6 Emblem
1-Adhesive Promoter
PROTECTIVE LINER INFORMATION: Your new accessories will come to you with a protective surface liner.
Leave this liner in place until the installation is complete to prevent finger prints and/or possible scratches
during installation.
1. Remove the factory hood panel (pad) by popping all the hood retainers off. Keep these fasteners; they
will be re-used to re-install the hood panel.
2. Wipe the indented C6 hood panel emblem with a cleaner to remove any kind of grease or dirt from the
road.
3. Use the supplied adhesive promoter packet and wipe the indented C6 hood panel emblem.
4. Now the C6 emblem will have 7 tabs sticking out of the back of the part. (These tabs a very pointy so
be careful while installing it so that you don’t poke yourself) These tabs will push through the factory
black hood pad and bend back onto the hood pad. Holding the emblem to the hood pad.