Peerless-AV PRS35 - Installation - Manual

ISSUED: 07-31-01 SHEET #: 055-9030-5 08-05-04
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
1 of 2
IMPORTANT! Read entire instruction sheet
before you start installation and assembly.
Installation and Assembly - Universal Projector Mount Models: PAP 35, PAP 35-S,
PAP 35-W
Before you start check the parts list below to
make sure all of the parts shown are included.
Description Qty. PAP 35 PAP 35-S PAP 35-W
A top plate 1 055-1144 055-4144 055-2144
B horizontal slide 2 054-1128 054-4128 054-2128
C vertical slide 2 054-1129 054-4129 054-2129
D M6 x 1 x 12 mm security screw 8 520-1050 520-2050 520-2050
E foam pad 3/8" x 12.75" x 1/8" 4 599-3802 570-0015 570-0015
F allen wrench 4 mm security 1 560-9646 560-9646 560-9646
G 1/4" flat washer 8 540-9440 540-9444 540-9444
H 1/4" lock washer 8 540-9402 540-9447 540-9447
I #10-32 x .75" socket pin screw 2 510-2128 510-2128 510-2128
Parts List
Note: Actual parts may appear slightly different than illustrated.
A
C
B
E F
Cut foam pad (E) to proper length to line Universal
projector mount assembly parts (A, B, C) as
shown. Peel off sticky back paper from foam pad
and attach.
H
G
D
I
PRS MOUNT
FASTENERS
Refer to PRS mount
instructions for adapter
plate attachment.
• Before installation, identify the location of all vents and
ports on the projector to ensure they will not be
obstructed by the universal mount. Blocked vents
may cause damage to the equipment.
CAUTION
• Installer must verify that the ceiling will safely support
four times the combined weight of all attached equip-
ment and hardware.
WARNING
B
C
E
E
E
E
A
E
E