Ingalls 37050 - Manual

Installation Instructions
1. Raise vehicle placing jack stand under the suspension.
2. Remove tire and wheel assembly.
3. Remove nut from OE adjuster.
4. Using a tie rod end puller remove the OE adjuster leaving the
bushing intact.
5. Replace OE adjuster with New adjuster.
6. Replace nut on bolt.
7. Replace tire and wheel assembly.
8. Using a 1-1/2" wrench adjust rear toe by rotating adjuster to
specification.
9. Torque nut to 60-86 ft. lbs. (81-115 Nm).
Copyright © 1997-04 INGALLS ENGINEERING Co., Inc.
ING3705-72297