Care and maintenance, Shutting off the water and electricity supplies, Cleaning the dishwasher – Hotpoint Ariston LFS 114 User Manual

Page 21: Preventing unpleasant odours, Cleaning the sprayer arms, Cleaning the water inlet filter, Cleaning the filters, Leaving the machine unused for extended periods

Advertising
background image

EN

21

Care and maintenance

Shutting off the water and electricity

supplies

• Turn off the water tap after every wash cycle to avoid

leaks.

• Always unplug the appliance when cleaning it and

when performing maintenance work.

Cleaning the dishwasher

• The external surfaces of the machine and the control

panel may be cleaned using a non-abrasive cloth
which has been dampened with water. Do not use
solvents or abrasive products.

• Any marks on the inside of the appliance may be

removed using a cloth dampened with water and a
little vinegar.

Preventing unpleasant odours

• Always keep the door of the appliance ajar in order to

avoid moisture from forming and being trapped inside
the machine.

• Clean the seals around the door and detergent

dispensers regularly using a damp sponge. This will
avoid food becoming trapped in the seals, which is
the main cause behind the formation of unpleasant
odours.

Cleaning the sprayer arms

Food residue may become encrusted onto the sprayer
arms and block the holes used to spray the water. It is
therefore recommended that the arms are checked from
time to time and cleaned with a small non-metallic
brush.
The two sprayer arms may both be removed.

To remove the upper sprayer
arm, rotate the locking ring in an
anti-clockwise direction.
The upper sprayer arm should
be replaced with the holes
facing upwards.

The lower sprayer arm can be
removed by pressing on the
side tabs and pulling it
upwards.

Cleaning the water inlet filter*

If the water hoses are new or have not been used for an
extended period of time, let the water run to make sure it
is clear and free of impurities before performing the
necessary connections. If this precaution is not taken,
the water inlet could become blocked and damage the
dishwasher.

Clean the water inlet filter at the tap outlet regularly.

- Turn off the water tap.
- Unscrew the end of the water inlet hose, remove the filter and
clean it carefully under running water.
- Replace the filter and screw the water hose back into
position.

Cleaning the filters

The filter assembly consists of three filters which remove food
residues from the washing water and then recirculate the
water. They should be cleaned if you wish to achieve the best
results in every wash.

Clean the filters regularly.

The dishwasher should not be used without filters, or if the

filter is loose.

After cleaning the filters, replace the filter assembly and fix it in
position correctly; this is essential for maintaining the efficient
operation of the dishwasher.

Leaving the machine unused for extended

periods

• Disconnect the appliance from the electricity supply and

shut off the water tap.

• Leave the door of the appliance ajar.

• When you return, run a wash cycle when the dishwasher is

empty.

• After several washes, check the filter assembly and if
necessary clean it thoroughly under running water, using a
non-metallic brush and following the instructions below:
1.

1.

1.

1.

1. Turn the cylindrical filter C in an anti-clockwise direction
and pull it out (fig. 1).
2.

2.

2.

2.

2. Remove the cup filter B by exerting a slight pressure on the
side flaps (fig. 2).
3.

3.

3.

3.

3. Slide out the stainless steel plate filter A (fig. 3).
4. Inspect the trap and remove any food residue. NEVER
REMOVE

the wash cycle pump (black detail)

(fig. 4).

*

Only available in selected models.

C

B

2

4

1

3

Advertising