S&B Filters Cold Air Intake Kit - Cotton Filter 75-5057 User Manual

Installation instructions, Vehicle application, Before you start

Advertising
background image

1.

With the ignition switched off and the

parking brake set, disconnect the negative
battery cables on both batteries. (Failure to
disconnect the batteries may result in a
Check Engine Light)

INSTALLATION INSTRUCTIONS

VEHICLE APPLICATION

Year: 2010-12
Make: DODGE
Model: RAM 2500/ 3500
Engine: 6.7L TURBO DIESEL

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 -

www.sbfilters.com

4.

Loosen the hose clamp at the turbo inlet,

next pinch the spring clamp and slide it up the
steel piping. Then disconnect the silicone
hose from the steel piping and remove spring
clamp.

7.

Carefully remove both sensors from the

stock air box and set them aside for now.

2.

Disconnect the electrical connection for

the Intake Air Temp. (IAT) Sensor and the
Mass Air Flow (MAF) Sensor then unsnap the
wire loom from the tube. (See the next step
for removal)

5.

Remove the mounting nut on the stock air

box.

8.

Remove the plastic clip holding the

coolant overflow tube to the fender. Remove
the clip from the tube and rest the tube on the
air inlet foam.

3.

For the MAF sensor, Slide the

red

locking

tab up then depress the black lever while
disengaging the connector. For the IAT
sensor just depress the

grey

lever while

disengaging the connector.

6.

Lift up and out to remove the stock air

box assembly from the vehicle.

9.

Use the supplied 8-32 SS Screws

(F)

and Sensor Gasket

(E)

, and install the MAF

sensor into Intake Tube

(C)

. Do not over

tighten.

P/N: 75-5057 / 75-5057D

SEE EXPLODED VIEW ON PAGE 4

1

Locking Tab

Lever

TOOLS REQUIRED

• 7mm, 8mm &10mm Wrench & Socket
• 7/16” Wrench & Socket
• 5/16” Nut Driver or Flat Blade Screwdriver
• Phillips Screwdriver, Pliers or Channel locks

NOTES

Kit may not fit with the following
Aftermarket Parts installed:
• Body Lift or Lowering Kit
• Custom Hood
• Intercooler or Turbo upgrades

S&B FILTER MAINTENANCE

Cleanable

(KF-1053)

. If the enclosed filter is Red, it came pre-oiled

from the factory. Please visit

www.sbfilters.com

for the exact oil

amount required after cleaning.

Disposable

(KF-1053D)

. If the enclosed filter is White, it is a

disposable filter and should be discarded once it reaches capacity.
This filter

(does not require oil)

. For more info on S&Bʼs disposable

filter, visit

www.sbfilters.com

.

BEFORE YOU START

• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer support at (909) 947-0015.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park or the Parking Brake is set.

Advertising