PolyPlanar MP3-KIT7 User Manual

Mp3-kit7

Advertising
background image





































1352 Charwood Road • Suite D • Hanover, MD 21076 • Tel (410) 761-4000 • Fax (410) 761-6274 www.polyplanar.com

MP3-KIT7

ME-60 Amp Settings

The ME-60 Amp is set at the factory at 80% of Max Volume.
In order to get Maximum Volume, adjust the Gain control fully
clockwise or to the desired level.

If the supplied Volume knob is used the MP3 player must be
set to full volume.

The Input Level should be set to “Line Level”


Adjust Player volume to full

Introduction:
The MP3-Kit7 is a simple system, designed to be used with MP3 audio storage devices (Ipod®, Mp3, etc).

System Overview:
The MP3-KIT7 consists of 2 MA7500 speakers, ME-60 120 Watt amp with volume control, MS55 box subwoofer and
an IC3.5PM Adapter.

Installation considerations:

Read and follow the installation instructions provided with each system component.

Disconnect Battery power before installing this system.

Be sure there is clearance before cutting or drilling any holes.

Mount the ME-60 amp on a vertical surface if possible. Use the 4 mounting tabs and screws provided.
Use a 1

” (25.4mm) drill bit or Paddle bit to drill the mounting hole for the Volume control knob. The volume

control knob is fitted with double stick gasket. Peel away the cover tape and press onto the dash. Plug the
Volume control into the 3.5 Phono connector of the ME60 amp.

Use a ¾” (19mm) paddle type bit or drill bit to drill the mounting hole for the 3.5PM Adapter. Connect the
ends to the ME-6

0 “RCA Type” Phono Plugs.

Use the instructional material and templates supplied, to install the speakers and the subwoofer. Be

sure to

use the

correct polarity on the speaker/subwoofer connections. These are clearly listed on the instruction

supplied with the speakers/subwoofer.

Connect Blue wire from Amp to ignition switch, panel switch or other switched 12 volt source. Please Note:
Blue wire not required if volume knob is connected.



Playing:

With the Amp on and connected to the Headphone jack of the MP3Player, Switch on the Player and set the
volume of the player to max volume. The control of the amp volume is handled by the Waterproof Volume
control knob supplied with the Amp

Use the Player controls to select Playlists or individual track.


12v - Negative

12v+ Positive

12v + Positive (Note: Blue
wire not required if volume
knob is connected)

MS55 Box
Subwoofer

MA-7500
Speakers

Advertising