Baldwin Reserve Round Knob - Half Dummy Knob User Manual

Measure and prepare door, Install knob/lever, Install trim

Advertising
background image

TEMPLATE

1. Measure and Prepare door

Measure your door for a backset of 2-3/8" (60mm) or 2-3/4" (70mm).

Refer to the template.

Drilling instructions for door preparation

1. Place desired fold line of template (below) on door edge with centerline
approximately 38" (965mm) from floor.

2. Mark screw hole centers.

3. Where marked, drill 1/8" (3 mm) diameter pilot holes, 3/4" (19mm) deep.

Place knob or lever onto chassis and turn set screw clockwise to secure.

3. Install knob/lever

Secure trim to door with screws.

2. Install Trim

Half Dummy Knob/Lever Installation Instructions

2-3/8" 60mm Fold • Doble • Plier

2-3/4" 70mm Fold • Doble • Plier

Centerline

Ligne médiane

Linea central

47037 / 01

Copyright © 2011 Baldwin Hardware Corporation

www.baldwinhardware.com

• Customer Service 1.800.437.7448

Please note: Product
illustrations may differ
from your product.
Installation is the same.

The set screws are pre-installed.
They do not need to be removed
prior to knob/lever installation.

Screw hole

Screw hole

The drilling template must be printed to scale
to ensure correct hole placement. To confirm
correct print scale, the square below must
measure exactly 1" by 1" (25mm x 25mm).

1"

25mm

1"

25mm

1"

25mm

Measure

after printing.

Advertising