Pro Series 44092 51 Receiver - Manual

Installation Instructions
Jeep Grand Cherokee
Part Numbers:
44092
51059
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm, 19mm
Drill Bits: None
3
Fascia
No Drilling Required
1.
Remove tow hook bracket if present.
2. Remove the M12 fasteners from the five (5) rearmost vehicle frame weldnuts. The skid shield will remain in place.
3. Raise hitch into position and install/re-install fasteners as shown above.
Note: Use existing fasteners if vehicle is equipped with reinforcement bars.
Rev. A 6-27-06 N51059 Sheet 1 of 1 z 2002, 2006 Cequent Towing Products
Spacer Qty. (2) 4 Lock Washer 1/2 Qty. (2) 2
Flat Washer 1/2 Qty. (2) 3 Hex Bolt M12 X 1.75 X 45 Qty. (2) 1
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: F51059
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
300 (136 Kg) 3500 (1589 Kg)
Weight Carrying
Ball Mount
500 (227 Kg) 5000 (2270 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV3
Skid shield
Frame
Existing weldnuts
Reinforcement
bar
For vehicles not
equipped with
reinforcement bars
For vehicles equipped with
reinforcement bars existing M12
fasteners
Skid shield
Existing hole
2
1
4
Tow hook
bracket
SERIES 51®
Form: F205 Rev A 5-6-05