SCANTECH ID (Champtek company) Discovery SG-20 - Manual (Page 60)

Ethernet Configuration 52
6.1.3 Interface Selection
At the Discovery with P/N A360103, the jumper setting for Ethernet must be:
The jumper location is described in the Discovery User’s Manual section 4.2.2.
1. At the Discovery with P/N from A360104 onwards, the interface selection
is done electronically and can simply be carried out by using the 4 buttons
of the Discovery. See section 5.1 for more details.
6.2 NETWORK PROTOCOLS
The Transmission Control Protocol (TCP) assures that no data is lost or
duplicated, and that every-thing sent to the connection arrives correctly at the
target. For typical datagram applications in which devices interact with other
devices without maintaining a point-to-point connection. The Internet Protocol
(IP) defines addressing, routing, and data block handling over the network.
6.2.1 INTERNET PROTOCOL (IP) ADDRESS
Every device connected to an IP network must have a unique IP address. This
address is used to reference the specific Discovery. See further for more
information on IP Addressing.
6.2.2
ETHERNET (MAC) ADDRESS
The Ethernet address of the individual SG-20 terminal, also referred as the
(unique) hardware address or the MAC address, can be found on the back of