Media-Tech PULSAR PRO BT - Manual

Stereo Bluetooth Headset
Pulsar Pro BT
MT3552
Pairing with mobile phone
1. Make sure that headset is charged, mobile phone is
turned on and Bluetooth function is active.
2. Power off the headset, then press and hold until
red and blue LED will fl ash alternately.
3. Run scanning for Bluetooth devices in your mobile
phone.
4. When prompted enter password “0000”. Some mo-
bile phones do not require password.
EN
User Manual
Overview
Operating
Function Operation
Power on Press and hold until blue LED will blink 3 times.
Power off Press and hold until blue LED blink, red LED will
blink 3 times and go off .
Pairing mode Press and hold until blue and red LED will fl ash
alternately.
Play/Pause Press
Next/Previous Press and hold +/-
Adjust volume Press +/-
Answer/End call Press
Reject call Double press quickly
Redial last number Double press quickly
Start up voice dialing* Press and hold until sound is played
Switch call Press and hold until sound is played
* Function depends on mobile phone capabilities
Specifi cation and appearance of product are subject to change without prior notice.
For technical support please visit www.media-tech.eu.
Charging
Use USB cable to plug device to USB port in your PC computer. During charging red LED will be on, when fully
charged red LED will be off .
Note! During charging device is always in off mode. When rechargeable battery is running low, red LED will
blink, charge the device.