AVSL 153.750 LR15 - Manual

LR15 Item ref: 153.750UK
RGB Signal Repeater User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
The LR15 is a signal repeater designed to allow extended runs of 12V or 24V RGB LED tape and strip.
Any RGB LED tape controller has a limited amount of current capacity, which means that it can only control a limited length of LED
tape. The LR15 acts as a signal repeater or amplifier so that further lengths of tape can be added to the controlled “incoming” length
of tape and all colours will be repeated across both tapes.
Setting up
 Connect the Blue, Red, Green and Voltage+ connections at the end of the incoming tape to the B, R, G and + screw terminals
labeled “SIGNAL IN”
 Connect the Blue, Red, Green and Voltage+ connections at the beginning of the continuation tape to the B, R, G and + screw
terminals labeled “OUTPUT”
 Connect an appropriate DC power supply for the LED tapes (either 12V or 24V) to the screw terminals labeled “DC IN”
1. SIGNAL IN Blue, Red, Green and Voltage+ connections from incoming LED tape
2. DC IN 12Vdc or 24Vdc power supply connection
3. OUTPUT Blue, Red, Green and Voltage+ connections to continuation LED tape