AVSL 153.770 ILA2 - Manual

ILC2 & ILA2
IN-LINE CONTROLLER &
AMPLIFIER FOR SINGLE COLOUR
LED TAPE
Item ref: 153.700UK, 153.770UK
User Manual
WARNING: This controller is intended for professional installation of single colour LED tape
and should be connected by qualified personnel in accordance with electrical safety standards.
Ensure that the rated load indicated is not exceeded.
Installation
The ILC2 controller can be employed to control single colour LED tape operating from a 5-
24Vdc power supply. Maximum short term current load is rated at 12A.
For constant full power output, it is advised to limit this to 6A load.
For Fluxia single colour LED tape (153.705-153.718UK), it is recommended to connect no
more than 3 x 5m tapes radially from the same controller. When connecting 5m tapes to make
a longer run (up to 15m), it is advised to use bypass wiring instead of connecting end-to-end
to avoid noticeable voltage drop at the furthest end from the power supply. Examples are
shown below.