Camp Chef MSSL Summit Solar Lantern - Manual

Summit Solar Lantern
www.CampChef.Com
Limited Warranty
manufacturer warrants this accessory to be free from defects in materials and workmanship for 90 days from the day of purchase. within this period,
manufacturer will replace or repair defective parts deemed unusable from its original intent by making available the parts thereof foB hyde park, UT 84318.
product finish is not warranted. misuse, abuse, overheating and alteration are not covered in this warranty. manufacturer will not be held liable for any losses
due to neglectful operation. No other warranties are implied. prior written approval and a return authorization number must be obtained. Returned items will be
accepted for repair or replacement only. Returns must be shipped prepaid. Collect shipments will not be accepted.
*applies to contiguous U.S. states only.
Instructions:
Charging Lantern:
Red light around the dial indicates batteries are charging. Blue light indicates a full charge.
Solar Charge:
open lid to expose solar panels. position the lantern in direct sunlight. It will take approximately 15
hours for a full charge.
AC Charge:
plug aC charge adapter into the lantern and plug it into 110V aC outlet.
Warning: Do not charge the battery for more than 5-6 hours when charging from aC adapter.
DC Charge:
plug DC charge adapter into the lantern and plug it into a 12 Volt DC car adapter.
Charging Cell Phones or other hand held devices from the lantern.
1. fully charge lantern using instructions above.
2. Using a USB cable for hand held devices, connect the lantern to the hand held device and follow
hand held instructions for charging.
Lantern Care
1. If using lantern on a daily basis, charge lantern in direct sunlight every day to keep the batteries
fully charged.
2. Turn lantern off when not in use.
3. If lantern is not used for more than 8 weeks, it is important to charge the batteries to maintain the
life of the batteries.
Using Lantern
The lantern can run on battery power when fully charged or plugged into aC or DC power for
continuous use. The blue light around the dial will be on when in use. Turn dial clockwise to desired
light setting.
0412-MSSL-Instructions.indd 1 5/1/12 10:43 AM